This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
linuxmce_ap [2016/01/23 20:50] – [/etc/network/interfaces] admin | linuxmce_ap [2016/01/23 21:52] – [Guest Network] admin | ||
---|---|---|---|
Line 188: | Line 188: | ||
rsn_pairwise=CCMP | rsn_pairwise=CCMP | ||
</ | </ | ||
+ | |||
+ | |||
+ | ==== / | ||
+ | |||
+ | <code config hostapd> | ||
+ | # Defaults for hostapd initscript | ||
+ | # | ||
+ | # See / | ||
+ | # methods of managing hostapd. | ||
+ | # | ||
+ | # Uncomment and set DAEMON_CONF to the absolute path of a hostapd configuration | ||
+ | # file and hostapd will be started during system boot. An example configuration | ||
+ | # file can be found at / | ||
+ | # | ||
+ | # | ||
+ | DAEMON_CONF="/ | ||
+ | |||
+ | # Additional daemon options to be appended to hostapd command:- | ||
+ | # -d show more debug messages (-dd for even more) | ||
+ | # -K | ||
+ | # -t | ||
+ | # | ||
+ | # Note that -B (daemon mode) and -P (pidfile) options are automatically | ||
+ | # configured by the init.d script and must not be added to DAEMON_OPTS. | ||
+ | # | ||
+ | # | ||
+ | </ | ||
+ | |||
+ | ====== Guest Network ====== | ||
+ | |||
+ | old mac address: | ||
+ | | ||
+ | 10: | ||
+ | | ||
+ | change it to **02**: | ||
+ | |||
+ | ifconfig wlan0 down | ||
+ | ifconfig wlan0 hw ether 02: | ||
+ | ifconfig wlan0 up | ||
+ | |||
+ |